Соединяются кабелем DMX OUT ведущего (Master) прибора и DMX IN ведомого (Slave). В соотв. с п.3 инструкции, на мастере жмете кнопку MODE, пока не появится 5-XX, дальше кнопками UP или DOWN выбираете необходимое шоу в диапазоне 0-20 или активацию по звуку 5-So. Затем на slave приборе жмете MODE до появления 4-XX.
Вот прямо в инструкции и написано
Цитата:
Сообщение от http://adjmedia.s3-website-eu-west-1.amazonaws.com/manuals/E_dekker.pdf
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR microphone cables to link your units together. Remember that the Male XLR connector is the input and the Female XLR connector is the output. The first unit in the chain (master) will use the female XLR connector
only. The last unit in the chain will use the male XLR connector only.
2. You will also have to link the power cords to each other, as you did with the XLR cables.
3. Choose your Master unit, and press the MODE button until “5-XX” is displayed. You are now in Master mode and you can use the UP or DOWN buttons to select your desired show from 0-20 or Sound Active (5-So)
4. With the “Slave” unit(s) press the MODE button until “4-XX” is displayed. They will now follow the “Master” unit.
|
|
