Цитата:
Сообщение от s.krivorozhsky
По USB в Device...драйвер винда либо сама найдёт (если не крякнутая) , либо скачать придётся...кабель USB-A - USB-B
|
Connections and settings
In order to connect Pa300 to a computer, you need a computer
with an USB port.
1. Install the Korg USB MIDI Driver, as explained in “Installing the Korg USB MIDI Driver” on page 380.
2. Connect Pa300 and the computer via the USB Device port.
3. Activate the “MIDI Thru” function on the external
sequencer. Please refer to the sequencer’s user manual.
4. On Pa300, select the “Extern.Seq.” MIDI Preset. You can do
this by going to the “MIDI: General Controls” page of the
Global mode. Note that this MIDI Preset will be remain
unchanged even when the instrument enters standby.
5. Go to the “MIDI: General Controls” page, and uncheck the
“Local Control On” parameter (see page 159). This is called
the “Local Off status”.
Note: Settings may change when new Global data is loaded
from a storage device. To protect settings from loading, use
the Global Protect function (see “Global Protect” on
page 154).
6. Press SEQUENCER to go to the Sequencer mode.
7. Play the keyboard. Notes played on the keyboard will go
from the USB port of Pa300 to the USB port of the computer.
Notes generated by the computer (i.e. a song played by its
sequencer) are sent from the USB port of the computer to
the USB port of Pa300.
The Local Off
When Pa300 is connected to an external sequencer, we recommend you to set the Pa300 in Local Off mode (see “Local Control On” on page 159) to avoid that the notes are simultaneously
played by the keyboard and by the MIDI events sent by the
external sequencer.
When Pa300 is in Local Off, the keyboard of Pa300 transmits
data to the external sequencer, but not to the internal sound generation. The sequencer will receive notes played on the keyboard
of Pa300 and will send them to the selected track of the song.
The track will then transmit data to the internal sound generation of Pa300.
Note: In order to send data to the sound generation of Pa300, the
“MIDI Thru” function must be activated in the external sequencer
(normally active; the name may be different according to the type
of sequencer). For more information refer to the instructions manual of the sequencer.
The Sounds
The song that is played back by the sequencer can select Pa300
Sounds through the MIDI messages Bank Select MSB, Bank
Select LSB (bank selection, two messages), and Program Change
(Sound selection). For a list of Sounds and MIDI values, see
“Sounds” on page 284.
As a hint for those who program songs on computer: even
though it is not mandatory, for a wider compatibility you should
set the bass on channel 2, melody on channel 4, drum kit on
channel 10, controls for an harmonizer on channel 5.
Цитата:
Сообщение от Калина
Значит, в аудионастройках компа нужно выставить линейный вход
|
Серёга это не карта компа...в моноблоке обычно даже карты нет...стоит дешманский цап скорее всего...